Sandvik rock support drill rigs are designed to drill holes and install bolts in rapid sequence safely, economically and effectively. Bolting mechanization ensures total realiability and integrity of every single bolt installation. These rigs can handle every types of bolt in various dimensions, including cable bolt. In all cases the operator conducts the entire operation from the safety of a well-protected control station on the rig. |  |
| Models |
| DS420 | Cabolt 7-5 | Up to 25 | 3.4 | 8.4 | TC 7 | Cable |
| DS310 | Robolt 5-126 XL | 1.5-3.0 | 2.95 | 6.7 | TC 5 | M & MW, S,
WI, GCR & GCC |
| DS410 | Robolt 7-3 | 1.5-3.0 | 2.85 | 7.9 | TC 7 | M & MW, S,
WI, GCR & GCC, BC, K |
| DS510 | Robolt 8-3 | 1.5-6.0 | 2.85 | 12.4 | TC 8 | M & MW, S,
WI, GCR & GCC, BC, K |
| DS520-TC |  | Up to 38 meters | 3.8 | 5.8 with hole drilling automation
8.8 without | TC 8 | Cable |
|
- Low profile rock support drill rigs
|
Sandvik low profile and extra low-profile rock support drill rigs are designed to drill holes and install rock bolts in mine sections with headroom as low as 1.6 and 1.1 meters respectively. Available in both semi-mechanized and fully mechanized models for LP sections, and semi-mechanized for XLP sections, they enable the operator to install bolts of various types quickly, safely and effectively. Both models are intended for use in tabular deposits. | |
| Models |
| DS210L | Robolt LP-126 XL | 1.5-2.3 | 1.7 | 2.25 | TC LP | M & MW, WI,
GCR & GCC |
| DS210L-M | Robolt LPM-126 XL | 1.11-1.85 | 1.6 | 1.905 | TC LP | M & MW, WI,
GCR & GCC |
| DS110L | Robolt XLP | 1.2-2.0 | 1.1 | 1.5 | TC XLP | M & MW & GCC |
| DS210L-V | Hybrid Bolter LP | up to 2.2 | 2.25 | 3.25 | TC LP | M & MW, S,
GCR & GCC |
(* = depending on bolt length)
M & MW = Mechanical & mechanical wedge bolts
S = Split Set bolts
WI = Water inflated bolts
GCR & GCC = Bolts grouted with resin or cement cartridges
BC = Bolts grouted with bulk cement
K = Kiruna bolts (combination of MW & BC)
|
|